Shimmer reverb Beta

MXM Shimmer

A reverb with a pitch shifter in its feedback loop, so the tail rises by an interval on every pass. Put the shifter on the input instead and you get a steady harmony above the room.

Mono or stereo in, stereo out12 presetsCLAP and VST®3
The MXM Shimmer editor: Space, Motion, Ascent and Loop cards The MXM Shimmer editor: Space, Motion, Ascent and Loop cards
The editor at its opening size962 × 385 · click for full size

Sound

The sound goes into a stereo reverb of eight modulated delay lines. Around it runs an outer loop that feeds the reverb’s output back into it, and a pitch shifter can sit in one of two places on that loop. Placement chooses. On Input, the shifter reads the incoming sound, so the shifted layer crosses the room once and stays at a fixed harmony. On Regen, it reads what comes back round the loop, so every pass is shifted up again and the tail climbs. Both runs the two together.

Shift sets the interval, from 0 to 24 semitones, always upward, with a separate voice for each side so the two channels stay apart. Shimmer sets how loud the shifted layer is, separately from how long the tail lasts, which is Regen’s job. The low and high cuts sit inside the loop, so each pass changes colour and the low end doesn’t build up into mud.

The shifter works by sweeping a delay, and you can hear the rhythm of its sweeps and their changing start point. That is deliberate texture. The restart of each sweep is faded to silence so it doesn’t click. Grain turns the sweep around, so each grain plays backwards before it is shifted.

Using it

Mono or stereo in, stereo out. Mix at zero turns the effect off: the dry sound passes untouched and the reverb empties, so turning Mix up again starts from silence. Regen is the only control that adds gain. Near the top of its travel the loop rings on by itself, and the larger the Size, the sooner that happens. Pre-delay and the drift rate can follow the host’s tempo.

Freeze holds the reverb’s current sound and keeps it circulating. The held sound stops climbing and stops passing through the cuts, so its pitch holds and its sound doesn’t narrow. New sound still gets in: each new note is shifted once and joins what is held. Switched on in silence, Freeze makes no sound until something plays.

The editor

Four cards: Space, Motion, Ascent and Loop. A display on the Space card draws arcs for the reverb spreading and rising marks for the shimmer climbing. It says Held while Freeze is on and Off when Mix is at zero. The editor opens at 962 × 385 with the four cards in a row, and can shrink to 360 × 360, with the cards moving onto pages.

Presets

12 factory presets, filed under Pad and FX: an octave hall that climbs, steady harmonies on the input, fifths, octaves, octave-and-a-fifth and two-octave shifts, reverse blooms, dark and airy spaces, a plain hall with no shift at all, and long washes. Init is an octave up on the Regen placement at a 48 % mix, set so that the shimmer is plain to hear the moment you insert it.

Status

Beta. MXM Shimmer is done and has passed our listening, presets included. It has worked in Bitwig.