MXM FX Curve
Instead of a threshold and a ratio, you draw the curve from input level to output level. Chain up to five of them, each a waveshaper or a dynamics stage.

Sound
In MXM FX Curve you draw the transfer curve yourself, input level across and output level up, through points you place. A stage works in one of two ways. Without its detector, the curve maps each sample directly, which makes it a waveshaper: saturation, clipping, folding or quantising. It shapes the wave’s upswings and downswings alike. With Linked detector on, the curve is read from the signal’s level, with an attack and a release, and the same drawing becomes compression, limiting, expansion or gating.
Up to five stages run in series, and their order matters: a compressor into saturation is not saturation into a compressor. Input gain drives only the processed path. Auto makeup gives back the level the curves take away. Mix blends the result with the untouched input, and at 0 % the output is exactly the dry signal.
Using it
Mono or stereo, with no latency and no tail. A detector stage links the two channels: the louder one sets a single gain for both, so the stereo image stays put. Antialiasing is automatic. Every change to a curve, and every preset load, crossfades over 20 ms.
Only Input gain, Auto makeup and Mix can be automated. The curves, their order and the detector settings are saved with the project and in presets. There is no look-ahead and no side-chain input.
The editor
MXM FX Curve doesn’t put its controls on pages. Along the top runs the serial chain, one chip per stage. Below it come the input fader and meter, the canvas, the output meter, and a column with the Stage card and the Output controls card. The canvas takes all the room the window has, so a larger window gives a larger curve to draw on.
The editor opens at 1024 × 760 and can shrink to 416 × 520. Below 840 wide, the canvas and the controls stack and the editor scrolls. Undo and Redo in the app bar hold 64 steps, and keep them when you close the editor.
Presets
60 factory presets: compressors and levellers, limiters, gates and expanders, saturation, hard clipping, fuzz, single, double and triple folds, step quantisers, and serial chains such as Compressor into saturation, Fold then clip and a Five stage crusher. Most use one stage; a dozen use two. Init does nothing at all: one stage with a straight line, so the sound passes unchanged until you draw. Most MXM effects start audible. This one doesn’t, on purpose.
Status
Beta. MXM FX Curve is done and tested.