MXM FX Convolution
Load one of a hundred rooms or a WAV of your own, then trim it, reverse it, resize it or reshape its tail. The response is saved inside your project.

Sound
MXM FX Convolution plays your sound through an impulse response, the recorded or rendered answer of a room, read from a mono or stereo WAV file. The start of the response is applied with no delay and the rest in blocks behind it, so the effect adds no latency.
Every response is brought to the same loudness when it loads, which makes Mix the one level to set: at 50 % the reverb is as loud as the dry sound, whichever room it is.
You can reshape a response without losing it: trim its start and end, reverse it, make it larger or smaller, shorten or lengthen its tail, shape it or damp it. Each change is worked out again from the untouched file. Pre-delay, a wet EQ, width, modulation and feedback act on the reverb as it plays.
MXM Impulses
MXM Impulses is a separate set of 100 rooms. MXM Portal installs it along with the plugin, and removes it when you remove the last plugin that uses it. We rendered the rooms with our own modelling tool. They are generic rooms, not copies of real buildings, in stereo at 48 kHz and up to 10 seconds long. They come in nine folders: chambers, halls, industrial, rooms, studios, transit, vehicles, venues and worship.
Every WAV in the folder shows up in the preset browser as a factory preset, named after its file. Put a WAV of your own in the folder and it shows up too. The set is about 165 MB and free under the GNU General Public License, version 3 or later.
Using it
Load a room from the preset browser, with Browse… on the Response card, or by dropping a WAV on the card’s display. The current response keeps playing until the new one is ready, then the two crossfade. The response is stored inside the preset or project, so a project opens on a computer that doesn’t have the file.
Mono or stereo in, stereo out. Mix at zero turns the effect off after a short fade. Feedback past 1.00 lets some responses sustain into a roar of their own. There is no limiter.
The editor
Four cards: Response, Time, Shape and Output. The Response card draws the response’s energy over ten seconds and marks the part in use. The editor opens at 951 × 555 and can shrink to 416 × 320, with the cards moving onto pages.
Presets
Its factory presets are the rooms of MXM Impulses, grouped by folder. Without the impulses installed, the list holds only Init. Init loads a short starter response of 7 ms, made by us, so the effect makes a sound as soon as you insert it.
Status
Beta. Loading, reshaping and the editor are done and tested. MXM Portal installs MXM Impulses with it, the hundred rooms it starts from.